X. Task A/B. Slow Flight and Flight Characteristics

⚠️ Disclaimer: This is for educational purposes only. I am not a certified flight instructor (CFI)... yet. (Working hard on it!) Until then, please don't use this as a substitute for professional flight training. Always consult a real CFI and follow your aircraft's POH. I accept no liability for any actions taken based on this content.

1. Lesson Objective

  • The student can fly at an airspeed where any further increase in angle of attack, load factor or reduction in power would cause a stall warning, maintaining altitude, heading and coordination in straight, turning, climbing and descending flight, clean and in landing configuration.

2. Content

  • Why slow flight; what it teaches (AFH objectives)
  • Configuration and target speed (clean and landing; Vs1 51, Vs0 44 KIAS)
  • How to fly slow and level: lift equation, angle of attack, induced drag, power required; pitch for airspeed, power for altitude
  • Region of reversed command
  • High angle of attack and high power effects: visibility, control effectiveness, left-turning tendencies, right rudder
  • Turns in slow flight: load factor, stall speed increase, bank limits
  • Weight and CG effects on stall speed (POH chart)
  • Demonstrating flight characteristics: changing configuration (flaps) and airspeed, and showing the effect on control effectiveness, trim, pitch attitude and stall warning
  • Exit procedure; private vs commercial standards
  • Procedures (setup CRAAC; slowing down clean/landing configuration; level turn; climb; descent; recovery)
  • AFH common errors; risks (collision hazards, distraction)

3. Schedule (ground about 1 hour; flight about 45 min)

Segment Time
Why, configuration, target speed 10 min
Aerodynamics: AOA, drag, reversed command 15 min
Control effects, turns, weight and CG 15 min
Exit, standards, procedures 15 min
Common errors and risks 5 min
Flight: demonstration and practice 45 min
Postflight debrief 10 min

4. Equipment

  • Laptop or projector with the deck
  • PA-28-161 POH (stall speeds, Vfe, flap limits) and school checklist
  • PA-28-161

5. Instructor’s Actions

  • Build up the aerodynamics step by step so the student understands why more power is needed at low airspeed.
  • Brief the procedure numbers and standards; set the altitude floor.
  • Demonstrate each configuration and maneuver, then coach right rudder, small bank and smooth power.

6. Student’s Actions

  • Explain the region of reversed command and why bank is limited in slow flight.
  • Slow to the target airspeed in the briefed configuration without a stall warning.
  • Fly level, turns, climbs and descents in slow flight and recover correctly.

7. Completion Standards

  • The student holds altitude ±100 ft (private; ±50 ft commercial), heading ±10°, airspeed +10/−0 kt, bank as specified, without activating the stall warning, finishing no lower than 1,500 ft AGL.
  • The student explains how configuration and airspeed changes affect control effectiveness, trim and stall warning.

8. References

  • Airplane Flying Handbook (FAA-H-8083-3), Ch. 5 Maintaining Aircraft Control: Upset Prevention and Recovery Training (slow flight, common errors)
  • Pilot’s Handbook of Aeronautical Knowledge (FAA-H-8083-25), Ch. 5 Aerodynamics of Flight (lift equation, drag, region of reversed command, load factor)
  • PA-28-161 Pilot’s Operating Handbook: Section 2 (airspeed limitations), Section 5 (stall speeds)
  • Private and Commercial Pilot Airman Certification Standards (maneuvering during slow flight)
Yaboong's Picture

Yaboong

Software engineer for seven years, now a pilot. CPL/IR, working toward CFI and the airline. Writing down what I learn along the way.
More about me →

Massachusetts, US gmail YouTube