V. Task D. Taxiing, Airport Signs, and Lighting (ASEL, AMEL)

⚠️ Disclaimer: This is for educational purposes only. I am not a certified flight instructor (CFI)... yet. (Working hard on it!) Until then, please don't use this as a substitute for professional flight training. Always consult a real CFI and follow your aircraft's POH. I accept no liability for any actions taken based on this content.

1. Lesson Objective

  • The student can plan and conduct a safe taxi at towered and non-towered airports, including clearances, readbacks and self-announcements.
  • The student can identify airport markings, signs and lighting, correct for wind while taxiing, and recognize and avoid runway incursion risks.

2. Content

  • Example flight: day VFR from Westfield-Barnes (KBAF, towered) to Orange (KORE); taxi at KBAF as the running example
  • Current airport information: airport diagram, hot spots, Chart Supplement, NOTAMs; KBAF hot spots HS1 and HS2
  • Pre-taxi checklist and briefing (brake check, controls for wind, PIC responsibilities, positive exchange of controls, taxi route, readbacks, sterile cockpit); setting up avionics before moving
  • Planning the taxi from ATIS (runways in use, intersection departure) on the satellite photo and airport diagram
  • Movement vs non-movement area and the boundary marking; Ground clearance before entering the movement area
  • Taxi clearances and readbacks (hold short readback, expectation bias example); non-towered CTAF self-announce at Northampton (7B2)
  • Safe taxiing technique: lights, clearing before turns, walking pace, power before brakes, following the centerline, sterile cockpit
  • Taxi risks: parallel active runways, runway change while taxiing, low visibility and progressive taxi, distractions
  • Taxiway markings at the ramp exit (boundary, edge, centerline); continuous vs dashed edge markings
  • Wind direction indicators and taxi control positions (quartering headwind, quartering tailwind) practiced on the KBAF ramp
  • Summaries (modules): Runway Incursion Avoidance, Airport Markings & Signs, Airport Lights

3. Schedule (about 1 hour 30 min)

Segment Time
Airport information, hot spots, pre-taxi briefing 15 min
Taxi planning at KBAF, movement area 10 min
Clearances, readbacks, CTAF announcements 15 min
Safe taxi technique and taxi risks 15 min
Taxiway markings and wind correction practice 20 min
Markings, signs and lighting review, runway incursion summary 15 min

4. Equipment

  • Laptop or projector with the deck
  • KBAF and 7B2 airport diagrams and hot spot pages (Terminal Procedures), Chart Supplement, current NOTAMs and ATIS
  • iPad with ForeFlight (taxi route, airport diagram)
  • Model airplane or yoke picture for wind-correction practice
  • Whiteboard and markers

5. Instructor’s Actions

  • Brief a real taxi from the KBAF ramp using the ATIS, airport diagram and hot spots.
  • Role-play Ground clearances, including a hold short instruction and an unexpected runway assignment, and correct readbacks.
  • Quiz the student on which line to follow at the ramp exit and on each sign and marking type.
  • Give wind and heading combinations and have the student place the controls; repeat after each turn on the taxi route.
  • Stress stopping the airplane before any heads-down task and asking for progressive taxi when unsure.

6. Student’s Actions

  • Find the hot spots and plan the taxi route before engine start.
  • Give the pre-taxi briefing and complete the brake check.
  • Make correct readbacks (towered) and self-announcements (non-towered).
  • Identify markings, signs and lights and state the required action for each.
  • Place the flight controls correctly for any wind direction while taxiing.

7. Completion Standards

  • The student plans and briefs a taxi route that accounts for hot spots and NOTAMs.
  • The student reads back all taxi and hold short instructions correctly and never crosses a hold short line without clearance.
  • The student correctly identifies all airport markings, signs and lighting covered.
  • The student positions the flight controls correctly for the wind and taxis at a safe speed on the centerline.

8. References

  • Airplane Flying Handbook (FAA-H-8083-3), Ch. 2 Ground Operations (taxiing, wind correction while taxiing)
  • Pilot’s Handbook of Aeronautical Knowledge (FAA-H-8083-25), Ch. 14 Airport Operations (markings, signs, lighting, wind direction indicators)
  • Aeronautical Information Manual: Ch. 2, Sections 1 and 3 (airport lighting, airport marking aids and signs); Ch. 4, Section 3 Airport Operations (ground control, taxiing, hold short readback)
  • AC 91-73 (Parts 91 and 135 Single Pilot, Flight School Procedures During Taxi Operations)
  • AC 150/5340-1 (Standards for Airport Markings); AC 150/5340-18 (Standards for Airport Sign Systems)
  • Chart Supplement and Terminal Procedures (airport diagrams, hot spots) for KBAF and 7B2
  • FAA runway safety resources (runway incursion avoidance)
Yaboong's Picture

Yaboong

Software engineer for seven years, now a pilot. CPL/IR, working toward CFI and the airline. Writing down what I learn along the way.
More about me →

Massachusetts, US gmail YouTube