IX. Task A. Steep Turns

⚠️ Disclaimer: This is for educational purposes only. I am not a certified flight instructor (CFI)... yet. (Working hard on it!) Until then, please don't use this as a substitute for professional flight training. Always consult a real CFI and follow your aircraft's POH. I accept no liability for any actions taken based on this content.

1. Lesson Objective

  • The student can perform steep turns (private about 45°, commercial about 50°) with coordinated control, holding altitude and airspeed, and explain the aerodynamics behind them.

2. Content

  • What a steep turn is and what it develops; turn classes and aileron pressure
  • Private vs commercial standards and sight pictures
  • Aerodynamics: vertical lift loss, more AOA, more induced drag, airspeed loss; add power early
  • Load factor (1/cos of bank) and stall speed increase; what it feels like
  • Turn rate and radius vs airspeed and bank
  • Control challenges: overbanking tendency, left-turning tendencies, adverse yaw, slip vs skid, left vs right turn rudder needs
  • Maneuvering speed and personal Va
  • Procedure: CRAAC setup, entry, in the turn, rollout (left and right)
  • AFH common errors and fixes; video
  • Risks: collision hazards, low-altitude stall/spin and CFIT, distraction

3. Schedule (ground about 50 min; flight about 45 min)

Segment Time
Definition, standards, aerodynamics, load factor 20 min
Control challenges and maneuvering speed 10 min
Procedure, common errors, video 15 min
Risks 5 min
Flight: demonstration and practice 45 min
Postflight debrief 10 min

4. Equipment

  • Laptop or projector with the deck (video)
  • PA-28-161 POH (maneuvering speed, stall speeds) and school checklist
  • PA-28-161; model airplane

5. Instructor’s Actions

  • Show the aerodynamic chain and load factor table so the student can predict what the airplane will do.
  • Brief CRAAC and the entry/rollout sight pictures.
  • Demonstrate both directions, then coach power, back pressure, rudder and rollout lead.

6. Student’s Actions

  • Explain load factor, stall speed increase and overbanking tendency.
  • Clear the area and set up at or below Va.
  • Fly 360° turns (commercial: then a turn in the opposite direction) holding altitude, airspeed and bank, rolling out on heading.

7. Completion Standards

  • Private: 45° ±5° bank, altitude ±100 ft, airspeed ±10 kt, rollout heading ±10°. Commercial: 50° ±5°, same altitude and airspeed limits, rollout ±10°.
  • The student keeps the turn coordinated and maintains outside scan for traffic.

8. References

  • Airplane Flying Handbook (FAA-H-8083-3), Ch. 10 Performance Maneuvers (steep turns, common errors); Ch. 3 (turns)
  • Pilot’s Handbook of Aeronautical Knowledge (FAA-H-8083-25), Ch. 5 Aerodynamics of Flight (load factor, Va, left-turning tendencies)
  • PA-28-161 Pilot’s Operating Handbook: Section 2 (maneuvering speed), Section 5 (stall speed chart)
  • Private and Commercial Pilot Airman Certification Standards (steep turns)
Yaboong's Picture

Yaboong

Software engineer for seven years, now a pilot. CPL/IR, working toward CFI and the airline. Writing down what I learn along the way.
More about me →

Massachusetts, US gmail YouTube