II. Task D. Principles of Flight

⚠️ Disclaimer: This is for educational purposes only. I am not a certified flight instructor (CFI)... yet. (Working hard on it!) Until then, please don't use this as a substitute for professional flight training. Always consult a real CFI and follow your aircraft's POH. I accept no liability for any actions taken based on this content.

1. Lesson Objective

  • The student understands the four forces, how a wing produces lift, the types of drag, and how lift and drag relate.
  • The student can explain stalls, load factor, stability and left-turning tendencies, and apply them to the PA-28-161.

2. Content

  • Four forces (lift, weight, thrust, drag) and their balance in steady flight, climbs and descents
  • Airfoil terms, angle of attack (AoA) and the AoA indicator, center of pressure, camber vs symmetric airfoils
  • How lift is produced: flow turning, Bernoulli’s principle, Newton’s third law; why the equal transit theory is wrong; the lift equation
  • Drag: parasite (form, interference, skin friction) and induced drag; wingtip vortices (linked from Wake Turbulence)
  • Lift/drag ratio, L/D max and best glide speed, effect of weight on best glide speed
  • Stall and critical AoA, airflow separation
  • Load factor, its effect on stall speed (PA-28-161 POH stall speed chart) and the V-g diagram (linked from Maneuvering Speed)
  • Stability, maneuverability and controllability; lateral, longitudinal, directional, static and dynamic stability
  • Left-turning tendencies (linked from the Left Turning Tendencies module)

3. Schedule (about 60 min)

Segment Time
Introduction and four forces 10 min
Lift (airfoil, AoA, Bernoulli and Newton, lift equation) 15 min
Drag and L/D (best glide) 10 min
Stall and load factor 10 min
Stability and left-turning tendencies 10 min
Review 5 min

4. Equipment

  • Laptop or projector with the slide deck (wind tunnel, Newton and Bernoulli videos, NASA FoilSim screenshots)
  • Whiteboard and markers (force diagrams, drag curve)
  • Model airplane (axes, AoA, stability)
  • PA-28-161 POH (stall speed chart)

5. Instructor’s Actions

  • Draw the four forces and explain their balance in level flight, climb and descent.
  • Define airfoil terms and AoA, and show the difference between AoA and pitch attitude.
  • Use the videos to explain flow turning, Bernoulli and Newton, and why the equal transit theory is wrong.
  • Draw the drag curve and locate L/D max and best glide speed; explain the effect of weight.
  • Explain the stall as an AoA problem, then load factor and stall speed with the POH chart.
  • Demonstrate the three axes and the types of stability with a model airplane.
  • Ask the student to explain each concept back.

6. Student’s Actions

  • Draw and label the four forces and an airfoil.
  • Explain how a wing produces lift and what the lift equation shows.
  • Identify parasite and induced drag on the drag curve and explain best glide speed.
  • Read the stall speed for a given bank angle from the POH chart.
  • Explain each type of stability and the left-turning tendencies.

7. Completion Standards

  • The student explains lift, drag, stall, load factor and stability correctly without notes.
  • The student explains that a stall occurs when the critical AoA is exceeded, at any airspeed, attitude or power setting.
  • The student correctly uses the PA-28-161 stall speed chart for a given weight and bank angle.

8. References

  • Pilot’s Handbook of Aeronautical Knowledge (FAA-H-8083-25), Ch. 4 Principles of Flight; Ch. 5 Aerodynamics of Flight (figures 5-10 and 5-11 wingtip vortices; 5-38 V-g diagram)
  • Airplane Flying Handbook (FAA-H-8083-3), Ch. 5 Slow Flight, Stalls, and Spins
  • PA-28-161 Pilot’s Operating Handbook, Section 5 (stall speed chart)
  • NASA Glenn Research Center, FoilSim (airfoil comparison)
Yaboong's Picture

Yaboong

Software engineer for seven years, now a pilot. CPL/IR, working toward CFI and the airline. Writing down what I learn along the way.
More about me →

Massachusetts, US gmail YouTube